虹科   联系虹科
夹子和刺针

蓄电池夹子TA157&TA158
蓄电池夹子TA157&TA158

这些钳型夹用于连接到汽车蓄电池端子,适合我们所有BNC-to-4mm的测试线。

TA161刺针
TA161刺针

像TA008中的探针,这些探针用来背刺多插头端子绝缘。TA161和TA162具有灵活的弯曲度,以改善困难区域的接入。每个探头适合我们BNC-to-4mm测试线的4mm插头。需要注意的是,与TA008中的探针不同,探针针尖是不可替换的。

Acupuncture Probe Set (TA008)

The TA008 is a back pinning probe
Top 20 motor toolsFirst and foremost the TA008 is a back pinning probe. In fact, it’s the smallest diameter back pinning probe that we know of. This is essential for probing today's small, fragile connector. It is also very sharp, so it slides past connector seals with ease. This product solves most of the problems associated with traditional back-pinning methods.

The TA008 is a piercing probe
Secondly, the TA008 is a piercing probe. Its small diameter, extra sharp pin makes it ideal for piercing the insulation on small gauge wires where traditional piercing tools might Acupuncture probescause damage.

The TA008 is field repairable
And finally, here's the best part. Don't you just hate it when you are using a back pinning probe and it bends or breaks? Before the TA008 came along, this meant that you had to buy a whole new back-probe. Not with the TA008; it's repairable. If the pin becomes damaged or useless in any way, simply take your pocket screwdriver, remove the set screw, pull out the old pin and install the new one! There's no need to replace the whole probe.

Contents:

  • 5 Complete acupuncture probes
  • 5 Screws
  • 30 Replacement needles
Large Dolphin/Gator Clips (TA005)
  • Length - 92 mm
  • Height - 37.5 mm
  • Depth - 15.3 mm
  • Clamping limit - 30 mm

Large dolphin crocodile/gator clipsThe crocodile clips are fully insulated with a 4 mm socket in the handle, offering an easy connection to the TA000 test lead. The toothed grip offers good contact on fine wire, with a 30 mm jaw opening limit.

Large dolphin crocodile/gator clips

 

Multimeter Probes (TA001)

Multimeter probes

  • Length - 115 mm
  • Diameter - 20 mm

The multimeter probes offer a quick and easy solution, where a permanent connection is not required. The 4 mm socket in the handle of the probe connects straight into the TA000 test lead.

Multimeter probes

Piercing Clips (TA007)

TPiercing Clipshe TA007 Insulation Piercing Test Clip set is ideally suited for automotive test and diagnosis. The piercing clips allow the user to provide the exact pressure needed to pierce the insulation of a wide range of wire types and sizes. The clips also feature a rotating banana jack that prevents the test lead from twisting and keeps the oscilloscope in the circuit while the wire is pierced, providing immediate confirmation that contact with the conductor has been made.

Piercing Probes

Shrouded to Unshrouded Adapter (TA016)

shrouder to unshrouded adapterShrouded-to-unshrouded adapters are for use with plugging the TA000 test leads into older style break out boxes that are not designed for use with shrouded 4 mm connectors.

 

BNC to 4 mm Adapter (MI078)

BNC to 4 mm plug adapterThe BNC to 4 mm adapter connects two 4 mm (“banana”) plugs to a BNC socket. If you have a sensor such as a current clamp with 4 mm plug outputs, for example, this adapter allows you to plug it into a Pico PC Oscilloscope with a BNC input. The 4 mm sockets and BNC plug are fully shrouded for safety.

Specifications
Maxiumum voltage 500 V CAT I
Maximum current 3 A
Maximum resistance 0.8 mΩ
Material Polyamide insulators (-20 °C to +80 °C), brass Ni ground contacts, brass Au / Co conductor
Length 63 mm (about 2.5 in)
Width 34 mm (about 1.4 in)
Height 18.5 mm (about 0.8 in)
Weight 24 g (about 1 oz)

 

Small Crocodile/Gator Clips (TA003)
  • Small crocodile/gator clipsLength - 54.5 mm
  • Height - 17.5 mm
  • Depth - 7.5 mm
  • Clamping limit - 11 mm

The crocodile clips are fully insulated with a 4 mm socket in the handle, offering an easy connection to the TA000 test lead. The toothed grip offers good contact on fine wire, with a 11 mm jaw opening limit.

 

 

Small crocodile/gator clips

MI168 – S-hook

s-hookThis small but essential accessory makes it easy to keep all those test leads tidy in the engine bay.

The S-hook is about 100 mm (4 in) long and coated in plastic and rubber to protect the vehicle's paintwork and your cables. Hook one end underneath the bonnet or hood, and use the other end to hang a bundle of cables up to about 25 mm (1 in) thick.



其它汽车示波器附件 >>>

 

 


汽车示波器产品系列
PP537 - 超级汽车示波器
PicoScope 4423汽车示波器
PicoScope 4223汽车示波器
PicoScope 2205-3汽车示波器

PicoScope 4423汽车示波器模块
PicoScope 4223汽车示波器模块
PicoScope 2205-3汽车示波器模块
PicoScope 汽车示波器软件

附件

汽车示波器资料库和培训课程

技术支持

论坛

人才招聘


英国Pico Technology专注USB示波器
研发20年!全球领先,多次获奖!


Email 汽车示波器论坛 点击发送消息给我

关于虹科虹科积极进取,不断探索科技新领域。最优秀的员工和最好的技术能够接受最困难的挑战。
为您找到最佳解决方案。虹科靠口碑赢得客户。

广州:400 999 3848;15986394869 | 上海:021-31215998 | 北京:010-57815068

sales@hkaco.com | 广州虹科电子科技有限公司 | 版权所有 | 华南理工大学 国家科技园2-504    

汽车诊断示波器
汽车示波器套装
模块
软件
附件
资料库和培训
技术支持
产品系列 公司介绍 培训课程 新闻快报 联系我们
77